Chris-Craft Launch 22 Owner's Manual download pdf (Page 97)

Systems

Chris-Craft 3–35

Using the Fresh Water System

On some models the water tank fill deck plate may be located in the

general vicinity of the fuel fill deck plate. DO NOT put fuel in the

water tank or water in the fuel tank.

Always keep the fresh water tank full. A full water tank helps keep the water potable. To fill the water tank:

1. Ensure the water supply is suitable for drinking. If filling from the dock check with the dockmaster to verify the

water is potable.

2. Remove the filler cap and fill the tank until water flows from the vent.

3. Secure the filler cap.

You will need to start the system whenever the tank is empty and air is in the supply lines. To start/use the

fresh water system:

1. Sanitize the system as previously described.

2. Fill the water tank with potable water.

3. Energize the pressure pump.

– The boat must have electrical power to energize the pressure pump. This can be the batteries, or if so

equipped, an external power source.

– Turn on the water pressure switch on the helm switch panel.

4. If a hot water system is installed on your boat, open a hot water faucet to fill the water heater and allow air to

escape from the line. Close the faucet when free of air.

5. Starting with the cold water faucet furthest from the pump, open each faucet until you see a steady stream of

water from each faucet. Close the faucets.

6. If the boat is equipped with a water heater, open the faucet furthest from the water heater first then open all

other faucets. Run until you see a steady stream of water from each faucet. Close the faucets.

7. Refill the water tank and turn off the pressure pump.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 301 302

No comments

Chris-Craft Launch 22 Owner's Manual Page 97